DS214play重置系统后，再也开不开机，一直闪蓝灯，拆开，主板拿出来，TTL接电脑上，显示 WARM_BOOT Intel(R) Consumer Electronics Firmware Development Kit (Intel(R) CEFDK) Copyright (C) 1999-2012 Intel Corporation. All rights reserved. Build Time (03/04/14 18:20:11). Searching 8051 FW in MFH... Load 8051 FW from MFH successfully! No active splash screen found in flash. Showing black screen. SMM: Ok ACPI Init: finished with table region from 00011aa0 to 00018000 acpi: Created tables at 00011aa0-00018000 PCIe Port0 setting: Auto PCIe Port1 setting: Gen1 CEFDK Version : CE5300 (SMP enabled) 8051 Firmware : C0-1.0.49 (0x00050000) 8051 FW I/O Module : NEC-1.0.082 Silicon Stepping : D0 (PCI) Silicon SKU : 0x07C Board : REF0 CPU Threads : 4 CPU Multiplier : 16 CPU Bus Speed : 100 MHz Memory Size : 1024 MB Memory Type & Speed : x16 DDR3-1600 (11-11-11) Memory Configuration : A B Interleave Mode 1 PCI Mode : PCI Standard Boot Mode : SPI-NOR mac address is the same, skip sync. Registered net controller: e1000e Registered net controller: e1000 Waiting for the Link up: - 1000M FD Link is ready! Configure IP via Bootp Mac address is : 00:11:32:4B:39:26 Host IP address is: 192.168.0.105 Subnet Mask is : 255.255.255.0 Gateway address is: 192.168.0.1 Press 'Enter' within 2 seconds to disable automatic boot. Hit a key to start the shell... ERROR: Invalid or missing kernel at 0x01000000. Attempting to boot Linux from NOR ... Kernel not found at 0xC0140000 in NOR, continue booting from HD. Attempting to boot Redboot... ERROR: No active Redboot found in flash. Attempting to boot Linux... ERROR: Invalid or missing kernel at 0x01000000. Attempting to boot from HDD... Attempting to boot redboot from Sector 1 of HD 0... No valid redboot found in HD(s). Reading boot sector...done. Error: Invalid boot sector. 网上查了下，好像是FLASH里面启动坏了，找了半天，看国外大神用这个命令 mfh list mfh delete kernel 0 mfh delete ramdisk 0 mfh add kernel 0 mfh add ramdisk 0 我照做了，但是故障依旧，有懂这方面的吗
